| A—length of load section mmB—height of conveyor chute mm
C—height of discharge section mm D—length of discharge section mm E—height of inlet to incline section mm F—width of the conveyor chute mm G—overall conveyor length mm H—height from floor to the conveyor bottom mm I—angle of the incline section °
Position of the drive arrangement on the discharge section in direction of carrying the chip or chunky material on: □ drive right side □ drive left side □ drive control □ overload guard □ reverse switch □ emergency-off switch
Tooling methods □ Turning on a lathe □ Milling □ Drilling □ Grinding □ Other
Amount of Swarf Kg/h dm³/h |
Chip charging□ Continuous
□ Amount of swarf per cycle kg
Swarf material □ Steel □ Cast iron □ Aluminium □ Brass □ Other
Swarf Special □ Short chips <8cm □ Long chips >8cm □ Chip bundle □ Chip and pieces
Required motor connection： □ 3×230V/50Hz/60Hz □ 3×380V/50Hz/60Hz □ 3×400V/50Hz/60Hz □ 3×480V/50Hz/60Hz
Available control voltage of the Switch board: □ 110V/AC □ 24V/DC |
Wet processing:□ Coolant tank capacity L
□ Amount of coolant supply L/min
Sort of coolant： □ Oil mm²/s@40℃ □ Emulsion mm²/s@40℃
Coolant outlet： □ Front □ Rear □ Lateral □ On both sides
Coolant Pump： □ Pump capacity L/min □ Pump pressure bar □ Pump capacity L/min □ Pump pressure bar
Other capacity: □ Level switch □ Bin full □ Bin empty □ Overflow preventer
Option: □ Chip bin |
Post time: Mar-09-2022